MIROTHANE PU Polyurethane Coatings

Mirotone’s range of clear and pigmented two pack polyurethane coatings are ideal for use on high quality fixtures and furniture. Easy to use and available in a range of gloss levels, Mirotone has the right system to meet your requirements. Typical applications include internal doors, kitchen cabinets, commercial joinery / wall panelling, domesticand commercial furniture. Premium systems available for bar & kitchen bench tops and marine fit outs.

 

MIROTHANE PU 5588 Clear Topcoat

MIROTHANE PU 5588 Clear Topcoat main image
MIROTHANE PU 5588 Clear Topcoat-image

Code: 5588

User friendly, easy to apply, clear polyurethane topcoat. Excellent flow and quick drying ensures an excellent finish and increased throughput.
Features:
  • Can be applied over a range of sealers including MIROCAT PC 3241 and MIROCAT PC 3242 Preact Sealers and MIROTHANE PU 5533 and MIROTHANE PU 5545 Polyurethane
  • Excellent flow and levelling
  • Economical – a cost effective furniture grade polyurethane topcoat

Specifications:

Colour : Clear
Finish : Satin (30%) and Satin (20%)
Build : Very Good
Sandability : Very Good
Vertical Hold Up : Good
Solvent Resistance : Very Good
Water Resistance : Very Good
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 6-7m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner

To View Tech Data Sheet and Safety Data Sheet: Register To View

Application:

Mixing Ratio (by volume) : 4 Parts 5588 Part A + 1 Part 5747 Part B (4A:1B) or 10 Parts 5588 Part A + 1 Part 5715, 5728, 5735 or 5757 (10A:1B)
Pot Life : 4-6 hours at 25°C Pot life varies significantly with ambient temperature, humdity and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job.
Thinning : Thin 20-40% with MIROSOL 1217 (Fast), 1263 (Medium), 1266 (Slow)
Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where To Use:

Interior use only. Domestic furniture, commercial joinery and kitchen cabinets

>