MIROTHANE PU Polyurethane Coatings

Mirotone’s range of clear and pigmented two pack polyurethane coatings are ideal for use on high quality fixtures and furniture. Easy to use and available in a range of gloss levels, Mirotone has the right system to meet your requirements. Typical applications include internal doors, kitchen cabinets, commercial joinery / wall panelling, domesticand commercial furniture. Premium systems available for bar & kitchen bench tops and marine fit outs.

 

MIROTHANE PU 5626 White Undercoat

MIROTHANE PU 5626 White Undercoat main image
MIROTHANE PU 5626 White Undercoat-image

Code: 5626

Premium grade, high solids, low viscosity two pack polyurethane undercoat. Very easy to sand and provides excellent DOI (Distinction of Image) when topcoated with a MIROTHANE PU topcoat gloss.
Features:
  • Easy to sand, powders easily making it ideal for hand sanding
  • High solids, low viscosity provides superior build with minimal thinning. Excellent for sealing the fibres of MDF.
  • Superior chemical and moisture resistance
  • Use up excess MIROTHANE PU 5650  topcoat by adding it into MIROTHANE PU 5626 to create your own tinted undercoat

Specifications:

Colour : White, Black & Tinted
Build : Very High
Sandability : Excellent
Vertical Hold Up : Excellent
Solvent Resistance : Excellent
Water Resistance : Excellent
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 6-7m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner

To View Tech Data Sheet and Safety Data Sheet: Register To View

Application:

Mixing Ration (by volume) : 3 Parts 5626 Part A + 1 Part 5747 Part B (3A:1B) or 5 Parts 5626 Part A + 1 Part 5715, 5728 or 5735 (5A:1B)
Pot Life : 2 hours at 25°C Pot life varies significantly with ambient temperature, humdity and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job.
Thinning : Thin up to 20% with MIROSOL 1217 (Fast), 1263 (Medium), 1218, 1266 (Slow)
Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where To Use: Interior use. Doors, kitchen & bathroom cabinets, commercial joinery and wall panelling and domestic furniture.

>