Q-STRIP
Code: 4925
- No strong caustic chemicals
- Removes coating without adversely affecting the underlying timber
- Will remove most conventional coatings
Coverage : 2.5 m² per litre
Clean Up : Water
Packaging : 1L, 4L, 10L & 15L
To View Tech Data Sheet and Safety Data Sheet: Register To View
Precautions : Do not use QSTRIP on plastic surfaces. Do not use if rain is forecast. Do not allow to dry out. Product works most efficiently between 15-25°C. Avoid applying in conditions of prolonged full sun.
Applications :
Good preparation is key to a professional looking, long lasting finish. Remove any loose or peeling paint and obvious solid soil or dusty agglomerates.
Wet Test a small area prior to application to determine the thickness (generally 3mm) of QSTRIP required and note the time (minimum 40 minutes) needed to allow it to work
Apply using a brush, roller or applicator pad, and leave QSTRIP for a minimum of 40 minutes to soften and dissolve the film. Thicker coatings may take a few hours. It is advisable to check a small area with a palette knife. If it removes easily proceed with the entire area.
On stubborn coatings use a stiff broom or brush, (pay close attention to cracks and grooves), then remove by scraping, scrubbing or power wash.
Generally, two applications will work, however sometimes a third application may be required. Leave to dry and examine. Repeat process in any areas that have not been removed until the entire area is acceptable.
Designed for timber but may be applied to glass, metal, concrete, plaster or masonry. (Refer to technical for more information).