MIROLAC NC Nitrocellulose & MIROCAT PC Pre-Catalysed Lacquers

Mirotone’s produces a high quality range of easy to use lacquers. Ideal for use on domestic furniture, internal doors and children’s toys and furniture. Easy to use and available in a range of gloss levels, Mirotone has the right system to meet your requirements.

MIROCAT PC 3210 Clear Topcoat

Code: 3210

User friendly, single pack, pre-catalysed clear lacquer for fixture and furniture finishing.

Features:

Easy to use, achieve an excellent finish with minimal effort
Ready for use (RFU), no thinning required, apply directly from the can
Good clarity, provide good grain definition and depth of colour
Excellent flow and levelling results in a smooth even finish

Specifications:

Colour : Clear
Finish : Satin (30%) & Semi Gloss (60%)
Build : High
Sandability : Excellent
Vertical Hold Up : Good
Solvent Resistance : Good
Water Resistance : Good
Levelling & Flow : Good
Sink Back : Minimal
Coverage : 6m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated.
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner

To View Tech Data Sheet and Safety Data Sheet: Register To View

Application:

Thinning : Thin up to 10% with MIROSOL 1222 or 1220 (Fast), 1294 (Medium), 1242 (Slow)

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where To Use: Interior use only. Ideal for domestic furniture, children's toys and furniture, picture frames, musical instruments, joinery and antique restoration