MIROTEC WB Water Based Coatings

Mirotone’s range of water based coatings are easy to use and low VOC making them ideal for use on domestic furniture, children’s toys and furniture, picture frames, musical instruments and antique restoration. MIROTEC WB 8052 is also ideal for use on bar and table tops, bathroom vanities and commercial work. Easy to use and available in a range of gloss levels, Mirotone has the right system to meet your requirements.

 

MIROTEC WB 8022 Clear Sealer

MIROTEC WB 8022 Clear Sealer main image
MIROTEC WB 8022 Clear Sealer-image

Code: 8022

Clear, single pack, water based sealer that is easy to apply, low yellowing and easy to sand.
Features:
  • Single pack, no pot life issues to manage and less waste of product
  • Easy to sand, powders easily ensuring the quickest time to sand
  • Water white and low yellowing, it is ideal for use over blonde timbers and liming stain
  • Good build, to further minimise the risk of sink back and tannin bleed, apply MIROTHANE PU 5500 Clear Isolator as a first coat on bare wood
  • Low VOC (solvent content), non flammable, low odour, safer for workers and the environment
  • Formaldehyde free, zero formaldehyde emissions in rooms in which coated articles are installed or used
  • Isocyanate free, does not require air assisted face masks or other respiratory personal protective equipment for application
  • Pthalate free, it is ideal for children’s toys
  • Complies with Green Building Council Australia: Green Star – Office Design v3 & Office As Built, Table IEQ-13.1 Maximum TVOC Content Limits for Paints, Varnishes and Protective Coatings

Specifications:

Colour : Clear
Build : Good
Sandability : Excellent:
Vertical Hold Up : Very Good
Solvent Resistance : Good
Water Resistance : Good
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 7m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment with water following use

To View Tech Data Sheet and Safety Data Sheet: Register To View

Application:

Thinning : Supplied ready for use (RFU). However if required, it may be thinned with up to 5% water depending upon application requirements. Note: only thin the volume of MIROTEC WB 8022 required for the job at hand. Once thinned the viscosity will continue to fall during the next 24 hours. If the application viscosity is too low, mix with some unthinned MIROTEC WB 8022 to bring the viscosity back up to the target.

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where To Use: Interior use only. Ideal for domestic and commercial furniture, children’s toys and furniture, picture frames, musical instruments, joinery and antique restoration.

>